Auto Pm Channel Storing; Resetting Programmable Memory - Kenwood TM-V7A Instruction Manual

AUTO PM CHANNEL STORING

After you recalled a PM channel, this function automatically
overwrites the current PM channel with the present
operating environment when:
• You recall another PM channel.
• You press [PM], [VFO].
• You switch OFF the transceiver.
Use the following procedures to activate this function:
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 4 (Memory).
CALL CALL
3 Press [ s s s s s ] , then select Item No. 4 (PM Auto Store).
CALL CALL
2
4 Press [SET] to toggle the function ON or OFF (default).
5 Press [MNU] again to exit Menu mode.
PWR PWR
VOL SQL
PWR PWR
VOL SQL
1

RESETTING PROGRAMMABLE MEMORY

Use this procedure to reset the PM channels to the factory
defaults.
1 Press [CALL]+ POWER ON.
• A confirmation message appears.
("PM Reset? Press [CALL]")
• To quit resetting, press any key other than [CALL].
2 Press [CALL] again.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
39