Table of Contents
Advertisement
INITIALIZING MEMORY
If your transceiver seems to be malfunctioning, initializing
the transceiver may resolve the problem.
Remember that initializing the memory channels requires
that you re-enter memory channel data again after the
initialization. On the other hand, initialization is a quick way
to erase all data from all channels.
Note: While using the Channel Display or All Lock function, you cannot
do Partial Reset nor Full Reset.
VHF Band Defaults
VFO
Version
Frequency
U.S.A./
144 MHz
Canada
Europe/
144 MHz
General
UHF Band Defaults
VFO
Version
Frequency
U.S.A./
440 MHz
Canada
Europe/
430 MHz
General
Tone
Frequency
Step
Frequency
5 kHz
88.5 Hz
12.5 kHz
88.5 Hz
Frequency
Tone
Frequency
Step
88.5 Hz
25 kHz
25 kHz
88.5 Hz
Partial Reset (VFO)
Use to initialize all settings except the memory
channels, the Call channel, the PM channels, and
Memory Channel Lockout.
1 Press [VFO]+ POWER ON.
•
A confirmation message appears.
("VFO Reset? Press [VFO]")
•
To quit resetting, press any key other than [VFO].
2 Press [VFO] again.
Full Reset (Memory)
Use to initialize all settings.
1 Press [MR]+ POWER ON.
•
A confirmation message appears.
("All Reset? Press [MR]")
•
To quit resetting, press any key other than [MR].
2 Press [MR] again.
Note: You can also do Partial Reset or Full Reset by pushing the RESET
switch on the transceiver {page 90}.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
35
Advertisement
Table of Contents
