Front Panel - Kenwood TM-V7A Instruction Manual

FRONT PANEL

1
Note: This section describes only the main functions of the front panel
2
controls and buttons. For the functions not described here, you will find
explanations in the appropriate sections of this manual.
3
4
5 CALL CALL
6
7
8
9
10
q q q q q CALL button
11
Recalls the Call channel {page 33}. Also starts or stops
Call/VFO Scan {page 48} when in VFO mode, or
12
Call/Memory Scan {page 48} when in Memory Recall
mode.
13
w w w w w VFO button
14
Selects the VFO mode {page 8}. In this mode you can
15
change the operating frequency, using the Tuning control
16
or Mic [UP]/[DWN]. Also provides:
• VFO Scan start/stop to scan the entire VFO range {page 44}.
17
• Program Scan start/stop to scan a programmed range of
18
frequencies {page 46}.
19
20
21
10
e e e e e MR button
Selects the Memory Recall mode {page 31}. In this mode
you can change memory channels, using the Tuning
control or Mic [UP]/[DWN]. Also starts or stops Memory
Scan {page 44}.
r r r r r Tuning control
Selects:
PWR PWR
• Operating frequencies when in VFO mode.
• Memory channels when in Memory Recall mode {page 31}.
• Menu Nos. when in Menu mode {page 19}.
This control is used for various other selections.
t t t t t MHz button
Selects the MHz mode. In this mode you can change the
operating frequency in 1 MHz steps or 10 MHz steps
{page 17}, using the Tuning control or Mic [UP]/[DWN].
Also starts or stops MHz Scan {page 47}.