Table of Contents
Advertisement
POWER-ON MESSAGE
Each time you switch the transceiver ON, the factory-default
message appears and stays for approximately 2 seconds.
You can program your favorite message in place of
"KENWOOD".
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 2 (Front Panel).
CALL
CALL
s s s s s
3 Press [
] , then select Item No. 2 (Power On Msg).
CALL
CALL
2
4 Press [SET] .
•
The last digit blinks.
5 Press [VFO].
•
The cursor moves to the first digit.
6 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the first digit.
PWR
PWR
VOL
SQL
PWR
PWR
VOL
SQL
1
•
To skip by four characters when operating the above
control or keys, press [MHz]. Press [MHz] again to quit
this jump function.
7 Press [
s s s s s
] .
•
The second digit blinks.
8 Repeat steps 6 and 7 to enter up to 7 digits.
•
After entering the 7th digit, pressing [
beep to sound.
To re-enter the preceding digit, press [
•
•
To clear all digits and move back to the first digit, press
[VFO].
9 Press [SET] again to complete the setting.
10 Press [MNU] to exit Menu mode.
DISPLAY DEMONSTRATION MODE
By initiating this mode, various pre-programmed displays
appear. You still can normally use the transceiver in this
mode. Pressing buttons or microphone keys, or turning the
Tuning control restores the operating display immediately.
If there is no button/key entry or Tuning control adjustment
for approximately 12 seconds, the transceiver reverts back
to Demonstration mode.
Press [F] + POWER ON to toggle the mode ON or OFF.
1
2
3
4
s s s s s
] causes an error
5
6
t t t t t
] .
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
69
Advertisement
Table of Contents
