Selecting Offset Direction - Kenwood TM-V7A Instruction Manual

144/440/430 mhz fm dual bander

Hide thumbs Also See for TM-V7A:

Table of Contents

Flow Chart for Repeater Access

Select a band.

Select a receive frequency.

Select an offset direction.

Select an offset frequency.

Activate the Tone function, if necessary.

Select a tone frequency, if necessary.

Press Mic [PTT].

Selecting Offset Direction

Select whether the transmit frequency will be higher (+)

or lower (–) than the receive frequency.

Press [F], [SHIFT] .

•

Each time you repeat this key operation, the offset direction

changes as shown below.

Simplex

TM-V7A/E

(VHF)

TM-V7A

(UHF)

Simplex

TM-V7E

(UHF)

If the offset transmit frequency falls outside the allowable

transmit frequency range, transmitting is inhibited until

the transmit frequency is brought within the band limits

by one of the following methods:

•

Move the receive frequency further inside the band.

•

Change the offset direction.

Note: While using a split memory channel or transmitting, you cannot

change the offset direction.

Table of Contents

Tm-v7e