1
Install the optional VS-3 unit to use this function {page 84}.
2
Each time you change the transceiver mode such as VFO
or Memory Recall, the transceiver automatically announces
3
the new mode.
4
The table below shows what the transceiver automatically
5
announces when it enters a new mode.
6
Key Pressed
7
[VFO]
[MR]
8
[CALL]
9
[PM]
10
[MNU]
11
[BAND SEL]
12
13
Mic PF key
programmed with
14
2
Enter {page 72}
15
1
When pressed in Memory Recall mode, the transceiver
announces the channel number, "channel", and the
16
frequency.
17
2
When pressed in VFO or Memory Recall mode.
18
19
20
21
82
VS-3 VOICE SYNTHESIZER (OPTIONAL)
New Mode
Announcement
VFO
"VFO"
Memory Recall
"MR"
"Call"
Call Channel
Programmable
"PM"
Memory
Menu
"Menu"
New TX/
Current frequency
Control band
Keypad Direct
"Enter"
Entry
In addition, the transceiver announces the displayed
information as follows when pressing Mic [6] in Microphone
Control mode {page 77} or the PF key programmed with
Voice {page 72}.
•
In VFO mode, announces the VFO frequency on the Control
band beginning with the 100 MHz digit. For the MHz decimal
point, announces "point".
•
In Memory Recall mode, announces the channel number,
"channel", and the frequency. For the L or U channels,
announces "low" or "up", the channel number, and the
frequency.
•
In Channel Display mode, announces only the channel
number. For the L or U channels, announces "low" or "up"
and the channel number.
•
In Call Channel mode, announces "call" and the frequency.
1
Note:
To deactivate the Voice Synthesizer function after installing the
optional VS-3 unit, access Item No. 3 (Voice) under Menu No. 14
(Audio), and select OFF.
While using Transceiver Lock or All Lock, the transceiver makes an
announcement only when pressing Mic [6] in Microphone Control
mode or the PF key programmed with Voice.
The Voice Synthesizer function does not work while transmitting or
scanning.