Table of Contents
Advertisement
3 Connect the other end of the connectorized front panel
cable to the One Touch panel.
•
The cut-away corners of the connector should be inserted
first into the space such that the corners mate with the
positioning tab.
Positioning tab
Cut-away corner
Screw
4 Install the front panel onto the One Touch panel by first
positioning the left rear edge of the front panel, then
pressing the right side of the front panel firmly against
the One Touch panel.
•
When the release switch clicks, the front panel is secured.
Bracket
5 Assemble the mounting brackets, and install the front
panel on the appropriate place in the vehicle.
•
When installing the front panel in the vehicle, use a
cushion under the bracket to protect the vehicle.
•
Adjust the angle of the front panel before firmly tightening
the two Allen screws.
•
Route the cable so neither the connections nor the cable
are under stress.
One Touch panel
Cushion
Allen
wrench
Allen screw
Cushion
Note: Consider the safety of driver and passengers when deciding
where to install the front panel. Tighten all screws firmly.
Self-tapping screw
(3 mm x 14 mm)
14 mm
Flat washer
Allen screw
Flat washer
6 mm
Self-tapping screw
(3 mm x 6 mm)
Onto the
appropriate place
in the vehicle
85
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Advertisement
Table of Contents
