Table of Contents
Advertisement
7
Installing the Blower Assembly
Parts needed for this procedure:
1
Blower assembly (from the Blower and Drive Kit)
1
Spring (from the Blower and Drive Kit)
Procedure
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects at you or bystanders,
resulting in serious injury. Also, contact with the
blade could occur.
• Never operate the lawn mower unless you install
a cover plate, a mulch plate, or a grass chute and
catcher.
• Make sure that the grass deflector is installed
when the grass chute and catcher are removed.
1. Remove the side discharge chute from the mower deck
(Figure
16).
Note: Save all the hardware and the side discharge
chute. Install the side discharge chute when the bagger
and blower are removed.
Figure 16
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Slide the blower-assembly peg into the pivot hole
(Figure 17
or
Figure
5. Spring installed
6. Grass deflector
7. L end of spring (place
behind the deck edge
before installing the bolt)
8. J–hook end of spring
18).
48- and 52-inch mower deck shown
1. Blower assembly
2. Mower deck
60- and 72-inch mower deck shown
1. Blower assembly
2. Mower deck
11
Figure 17
3. Pivot hole
4. Blower-assembly peg
Figure 18
3. Pivot hole
4. Blower-assembly peg
Advertisement
Table of Contents
