Advertisement
1. Idler pulley
2. Mower deck pulley
3. Spring
6
Installing the Blower
Assembly
Parts needed for this procedure:
1
Blower assembly
Procedure
WARNING
An uncovered discharge opening could allow
the mower to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
• Never operate the lawn mower unless you
install a cover plate, a mulch plate, or a
grass chute and catcher.
• Make sure that the grass deflector is
installed when you remove the grass chute
and catcher.
1.
Remove the side discharge chute from the
mower deck
(Figure
Figure 9
4. Peg
5. Belt
6. Blower pulley
10).
g003398
1. Bolt
2. Spacer
3. Locknut
4. Spring
2.
Slide the blower assembly peg into the pivot
hole
(Figure
1. Blower assembly
2. Mower deck
3.
Close the blower assembly to see if the latches
are adjusted correctly. Loosen or tighten the
bolt so that the latches firmly hold the blower
assembly against the mower deck but can be
released by hand
7
Figure 10
5. Spring installed
6. Grass deflector
7. L-end of spring; place
it behind the deck edge
before installing the bolt.
8. J-hook end of spring
11).
Figure 11
Model 31213 shown
3. Pivot hole
4. Blower assembly peg
(Figure
12).
g002519
g011124
Advertisement
