Installing The Blower Assembly - Toro 79348 Manual

4. Lift the bagger top and install the bags
assembled in 9 Assembling the Grass Bags
(page 15) by sliding the bag frame hooks onto
the retaining brackets
Figure 21
5. Lower the bagger top onto the bags
Figure 22
6. Secure the hood with the latch
(Figure 21).
g300378
(Figure 22).
g033030
(Figure 22).
11
Installing the Blower
Assembly
Parts needed for this procedure:
1 Blower assembly
Procedure
WARNING
An uncovered discharge opening allows the
lawn mower to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
• Never operate the lawn mower without a
cover plate, a mulch plate, or a grass chute
and catcher.
• Make sure that the grass deflector is
installed when you remove the grass chute
and catcher.
Important:
Install the side-discharge chute when
you remove the bagger and blower.
Important:
Save all the hardware and the
side-discharge chute.
1. If necessary, install the belt onto the blower
pulley (Figure
2. Insert the blower pivot pin into the blower
support and rotate the blower assembly inward
toward the machine
Note:
The blower assembly should
automatically latch as shown in
16
25).
(Figure 23).
Figure 24.