Advertisement
5
Routing the Blower Belt into
the Blower Assembly
Parts needed for this procedure:
1
Blower belt
1
Spring
Procedure
1. If present, cut the existing belt cover bracket so that it
is flush with the edge of the top deck assembly; refer
to
Figure
8.
Note: Remove any sharp edges.
Note: Upon removal of this kit, install the new cover
bracket; refer to
10 Installing the New Belt Cover
Bracket Upon Removal of the Kit (page
1. Existing bracket
2. Install the belt around the blower pulley
3. Install the spring to the idler arm and the peg on the
blower assembly
(Figure
11).
Figure 8
2. Edge of top deck assembly
(cut existing bracket flush
with this)
(Figure
9).
1. Idler pulley
2. Mower deck pulley
3. Spring
6
Installing the Blower Assembly
Parts needed for this procedure:
1
Blower assembly
Procedure
WARNING
An uncovered discharge opening could allow the
mower to throw objects toward you or bystanders,
resulting in serious injury. Also, contact with the
blade could occur.
• Never operate the lawn mower unless you install
9).
a cover plate, a mulch plate, or a grass chute and
catcher.
• Make sure that the grass deflector is installed
when you remove the grass chute and catcher.
1. Remove the side discharge chute from the mower deck
(Figure
10).
6
Figure 9
4. Peg
5. Belt
6. Blower pulley
Advertisement
