Preparing The Machine; Installing The Side Bumpers; Procedure Description Qty; No Parts Required - Toro 78562 Manual

Procedure
11
12
13
Note: Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Machine

No Parts Required

Procedure
Perform the following procedure to prepare the machine for
attaching the blower and finishing kit.
1. Disengage the PTO, move the motion-control levers
to the N -L
EUTRAL OCKED
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Repair all bent or damaged areas of machine deck and
replace any missing parts.
4. Clean the machine of any debris on the machine deck
or rear part of the machine to ease installation.
2

Installing the Side Bumpers

Parts needed for this procedure:
1

Left bumper

1

Right bumper

2

Carriage bolt (3/8 x 1-1/4 inches)

6

Flange nut (3/8 inch)

Procedure
1. Remove the nuts and bolts holding the side bumpers
to the machine (Figure
Note: Discard all nuts and only the 1 bolt removed
from each side.
Description
Bumper
Spacer
Locknut (5/16 inch)
No parts required
No parts required
position and set the parking
5).
Qty.
2
Install the bumpers (for machines with
2
MyRide™ suspension system).
2
–
Adjust the parking brake.
–
Check the tire pressure.
2. Install the new left and right side bumpers with 2
carriage bolts (3/8 x 1-1/4 inches), 4 previously
removed carriage bolts, and 6 flange nuts (3/8 inch) as
shown in Figure
1. Flange nut (3/8 inch)
2. Right bumper
3. Use existing bolts
6
Use
5.
Figure 5
4. Left bumper
5. Bolt (3/8 x 1-1/4 inches)