Removing And Installing The Light Bulb For The Turn Signal Light - Skoda Karoq 2018 Workshop Manual

Karoq 2018 ➤
Electrical system - Edition 10.2017
4.6 Removing and installing the light bulb for
the turn signal light
Removing
– Switch off the ignition and all electrical components.
– Remove tail light
⇒ "4.2 Removing and installing tail light", page 93
– Unclip the bulb holder -1- from the catch pegs -arrows- and
remove.
– Remove defective light bulb -2- (WY16W) from the socket and
replace.
Installing
Installation is performed in the reverse order, pay attention to the
following points:
Caution
Hazard caused by water ingress and functional faults of the
light.
When inserting the lights into the assembly opening, ensure
that the connection wiring loom is inserted into the vehicle
cockpit.
Crushed cables between the body and lights causes significant
leakage of rainwater and light malfunctions.
96
Rep. gr.94 - Lights, bulbs, switches - exterior
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�