Table of Contents
Advertisement
- Low beam and main beam
B
- Parking and daytime running light
C
Changing the bulb for the front turn signal light
›
Turn the bulb holder
» Fig.
122anti-clockwise up to the stop and remove.
A
›
Push the faulty bulb into the holder, turn in anti-clockwise up to the stop and
remove.
›
Insert a new bulb into the socket and turn clockwise to the stop.
›
Insert the lamp holder with the new bulb into the headlamp and turn it clock-
wise until it stops.
Replacing the bulb for low beam and main beam
›
Remove the connector on the bulb
›
Remove the rubber cover.
›
Press the circlip
in the direction of the headlamp and then unhook in the di-
D
rection of the arrow.
›
Remove the light bulb and insert a new light bulb in such a way that the fixing
lugs of the light bulb socket fit into the recesses at the headlight.
Installation is carried out in the reverse order.
Replacing the bulb for the front parking light and daylight running light
›
Turn the bulb holder
» Fig.
122anti-clockwise up to the stop and remove.
C
›
Remove the faulty bulb from the socket.
›
Insert a new bulb into the socket.
›
Insert the lamp holder with the new bulb into the headlamp and turn it clock-
wise until it stops.
Changing the light bulb for side repeater turn signal lights
Fig. 123 Right side: Replacing the bulb for the turn signal light
142
Do-it-yourself
» Fig.
122.
B
ä
First read and observe the introductory information and safety warn-
ings
on page 141.
›
Push the side repeater turn signal light in the direction of the arrow
» Fig.
123.
1
›
Prise the turn signal light from the body in the direction of the arrow
›
Remove the bulb holder
3
›
Remove the faulty bulb from the socket.
›
Insert a new bulb into the socket.
›
Replace the bulb holder.
›
Set the side repeater turn signal light with the side facing the rear of the vehi-
cle in the body and lightly press it until the spring on the other side of the side
repeater turn signal light latches.
Changing light bulbs for fog lights
Ð
Fig. 124 Front wheel houe: Changing light bulbs for fog lights
ä
First read and observe the introductory information and safety warn-
ings
on page 141.
›
Unscrew the two attachment bolts on the wheel house trim with the screw-
driver
» page
127, Vehicle tool kit (arrows)
›
Undo the expanding rivet
A
flat, dull object, such as a coin, remove.
›
Fold the wheel house trim to the side, remove the connector
›
Turn the lamp holder (bulb set- holder including bulb) anti-clockwise as far as
the stop, remove.
›
Insert the lamp holder with the new bulb into the headlamp and turn it clock-
wise as far as the stop; insert the connector until it latches securely.
›
Fold the wheel house trim back.
in the direction of arrow.
» Fig.
124.
» Fig. 124
below on the wheel house trim with a
1
.
2
Ð
.
£
Advertisement
Chapters
Table of Contents
