Installing Repair Kit For Headlight Housing; Changing Headlights Over From Driving On Right To Driving On Left - Skoda Karoq 2018 Workshop Manual

Karoq 2018 ➤
Electrical system - Edition 10.2017
– Detach the mount with lamp from the detents by pulling in the
direction of arrow -B- -1-, arrow -A-.
– Remove defective light bulb from the socket and replace.
Installing
Installation is carried out in the reverse order.
1.5

Installing repair kit for headlight housing

If the headlight fixing brackets are broken or damaged, they can
be replaced by installing the repair kit. The complete headlight
must not be replaced.
Note
Before repairs check if the headlight has no other damage, as
♦
the repair would be senseless.
The replacement brackets can be ordered separately see ⇒
♦
Electronic Catalogue of Original Parts "ETKA" .
Before repairs the headlight must be removed
♦
⇒ "1.2 Removing and installing headlight", page 72
After installing the headlight, adjust the headlight
♦
⇒ "1.3 Setting the headlight beam", page 73
– Remove the remains of the original crate.
– Change the contact surface (grind off, remove by file) to allow
a new bracket to be inserted properly.
– Install a new bracket -arrows- with adjusting screw already
screwed in flush to the profile.
– Screw on the new bracket with self-tapping screws.
Specified torques
Component
Fixing screws for new bracket
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1.6 Changing headlights over from driving
on right to driving on left
Adjusting halogen headlights:
Luminous flux of a halogen headlight is not adjusted when trav‐
elling in countries with traffic on the left-hand side.
Adjusting FULL-LED headlights
Adjusting the luminous flux of a FULL-LED headlight when driving
in countries where vehicles drive on the left-hand side is done by
making a change to the software setting in the vehicle.
74
Rep. gr.94 - Lights, bulbs, switches - exterior
.
.
Tightening torque
1.5 Nm