Install Swing Gate Assembly - Ariens Sno-Thro Professional Series Service Manual

12. Remove two hair pins retaining swing gate assembly
to swing gate pivot pin and remove pin. See Figure 45.
WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
13. Disengage traction drive belt from traction drive pulley
and remove swing gate assembly. See Figure 46.
Figure 45
Figure 46

Install Swing Gate Assembly

WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
1. Position swing gate assembly inside frame.
2. Reinstall traction drive belt on traction drive pulley.
3. Reinstall pivot rod through swing gate and secure in
tractor frame with two flat steel washers and hairpin.
See Figure 47.
EN – 25
Figure 47