Assembly - Ariens Sno-Thro Deluxe Track 24 Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
PACKAGE CONTENTS
2
4
1. Sno-Thro
Unit
2. Discharge
Chute
3. Chute Crank
Figure 3

ASSEMBLY

Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
ASSEMBLY
3
1
OS7021
4. Literature
Pack with
Extra Shear
Bolts
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the
second reverse position.
4. Rotate the handlebars into operating
position.
IMPORTANT: Be careful not to damage cable
spring hooks when rotating handlebars
upward.
5. Install and tighten all hardware on the
handlebar assembly and shift rod.
3
1, 2
OS7030
1. Handlebar
Hardware
2. Shift Rod
Hardware
Install Discharge Chute and
Discharge Chute Crank
(Figure 5)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing (Figure 5).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTE: Leave discharge chute pedestal loose
to help install the chute crank.
GB - 10
4
2
3. Shift Rod
4. Speed
Selector
Lever
Figure 4