Ariens Sno-Thro Professional Series Service Manual page 11

12. Remove chute deflector cable from J-clamp on engine
mount. See Figure 6.
See Figure 7.
13. Fully loosen tapping screw securing left side of belt
cover to frame. Tapping screw stays attached to belt
cover.
14. Loosen, but DO NOT remove tapping screw securing
right side of belt cover to frame. Remove belt cover.
Figure 6
Figure 7
15. Remove hardware retaining belt finger to engine and
remove belt finger. See Figure 8.
WARNING: AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to remove
belts from attachment sheave.
EN – 9
Figure 8