Install Chute Rotation Gear - Ariens Sno-Thro Professional Series Service Manual

See Figure 95.
IMPORTANT: Support discharge chute so it remains
upright.
6. Remove hardware securing chute rotation gear to
pedestal plate and remove chute gear.
4
1. Center Locking Flange Nut
2. Flange Bushing
3. Hex Bolt
4. Chute Rotation Gear
3
1
Figure 95

Install Chute Rotation Gear

IMPORTANT: Ensure discharge chute is positioned facing
forward.
See Figure 96.
1. Position actuation gear so gear teeth are at lowest
position.
2. Install chute rotation gear so midpoint of gear teeth is
seated in chute lock arm. Secure to pedestal with hex
bolt, flange bushing and flange nut.
IMPORTANT: Ensure that calibration markers on actuation
gear and chute rotation gear align.
2
1. Actuation Gear
2. Chute Rotation Gear
3. Chute Lock Arm
4. Calibration Markers
3. Position chute rotation lever upright and discharge
chute facing forward.
4. Reinstall hex rod into chute actuation gear and secure
with hairpin.
5. Reinstall chute gear cover and secure with tapping
screw.
6. Adjust discharge chute. Refer to Operator's Manual
for adjustment procedure.
7. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
EN – 45
1
3
2
Figure 96
4