Install Right Axle Bearing - Ariens Sno-Thro Professional Series Service Manual

Install Right Axle Bearing

1. Align bearing with bearing plate and position on frame
with three hex bolts from inside frame. Retain with
three locking nuts.
See Figure 84.
2. Reinstall short axle until a small portion of axle is
through frame.
3. Reinstall two flat steel washers onto short axle.
4. Align differential gear with pinion gear and short axle
and reinstall axle into differential. Reinstall sleeve
spacer.
4
2
1. Short Axle
2. Flat Steel Washer
3. Differential Gear
4. Pinion Gear
5. Sleeve Spacer
1
3
Figure 84
See Figure 85.
5. Reinstall long axle into differential gear.
6. Reinstall E-ring onto axle end.
7. Reinstall bottom cover and secure with two tapping
5
screws and four hex bolts.
8. Ensure axle key is in position and reinstall wheel.
Secure with snap clip.
9. Return unit to operating position.
10. Reconnect spark plug wire and fill fuel tank.
EN – 40
Figure 85