Install Traction Drive Idler Assembly; Install Attachment Drive Idler Assembly - Ariens Professional Sno-Thro Series Service Manual

Install Traction Drive Idler Assembly

See Figure 31.
1. Reposition torsion spring leg around idler arm.
IMPORTANT: Ensure idler arm has tension.
2. Reinstall second torsion spring and attachment idler
arm hub onto pivot rod.
See Figure 32.
3. Align attachment arm idler hub with hole through pivot
rod and reinstall roll pin.
4. Reinstall traction drive cable end onto traction drive
idler arm and secure with original flat steel washer and
hairpin.
5. Reinstall attachment drive idler assembly. See Install
Attachment Drive Idler Assembly on page 19.
Figure 31
Figure 32

Install Attachment Drive Idler Assembly

See Figure 33.
1.
2. Secure attachment drive idler assembly to hub with
original tapping screws.
3. Reposition torsion spring leg around idler arm.
IMPORTANT: Ensure idler assembly has tension.
4. Reinstall attachment brake spring onto frame. See
Figure 34.
5. Reinstall auger housing. See Reinstall Auger Housing
on page 11.
EN – 20
Figure 33
Figure 34