Install Traction Drive Idler Assembly - Ariens Sno-Thro Professional Series Service Manual

Install Traction Drive Idler Assembly

See Figure 25.
1. If removed, reinstall traction drive belt.
2. Reinstall traction drive idler assembly and torsion
spring onto idler pivot rod.
3. Reinstall attachment idler arm hub onto idler pivot rod.
Figure 25
See Figure 26.
4. Align attachment arm idler hub with hole through pivot
rod and reinstall roll pin.
5. Reinstall idler spring onto traction drive idler arm and
ensure traction drive belt is aligned in all pulleys.
6. Reinstall attachment drive idler assembly. See Install
Attachment Drive Idler Assembly on page 18.
EN – 17
Figure 26