Stiga Stig 300 Instruction Manual page 60

PROBLEM
"Out of perimeter "
appears on the app.
"Lifted Robot"
appears on the App
"Wheel error" appears
on the app.
The app displays "Tall
Grass" or "Mowing
Error".
The App displays
"Tipping".
56
7. TROUBLESHOOTING
CAUSES
Ground slopes too much
Perimeter cable laid in the wrong
way
Perimeter cable for delimiting
internal areas (flower beds,
bushes, etc.) incorrectly laid.
Overheated power supply unit.
The robot lawn mower is lifted
from the ground.
Uneven ground or with obstacles
stopping the movement.
One or both motors working the
wheel drive have failed
Blocked or damaged cutting disc.
Pivoting cutting blades worn
or blocked by encrustations or
residues.
The robot lawn mower was started
in the presence of unexpected
obstacles (fallen branches,
forgotten objects, etc.).
Electric motor failure
Grass too tall
The robot lawn mower is on a
slope that is higher than the
allowed limits.
SOLUTIONS
Delimit the area with excessive slope
(see Par. 4.3)
Check that the cable is installed correctly
(excessive depth, proximity to metal objects,
distance between the cable that delimits two
elements, etc.). (See Par. 4.5.1).
Reposition the perimeter cable
correctly (go around the obstacle in the
same direction of travel of the perimeter.)
(See Par. 4.5.1).
Adopt suitable solutions to reduce power
supply unit temperature (air or modify
installation area, etc.) (see Par. 4.3)
Check that the robot lawn mower is not
blocked or obstructed by any objects. Clean
and remove any grass residues under the
hood that may obstruct the sensors
(See Par. 6.2).
Check that the lawn to be mowed is uniform
with no holes, stones or other obstacles.
If it's not, carry out the necessary
environmental decontamination operations
(see Par. 4.3).
Replace the motor, contact the nearest
authorized service centre.
Stop the robot lawn mower in safety
conditions (see Par. 2.3). Release the
cutting disc from objects that cause it to
block or replace the cutting disc with a new
one (see Par. 6.3).
Switch off the robot lawn mower in safety
conditions (see Par. 2.3). Unblock and clean
or replace the cutting blades (see Par. 6.3).
Switch off the robot lawn mower in safety
conditions (see Par. 2.3). Remove the
obstacles and restart the robot lawn mower.
Replace the motor, contact the nearest
authorized service centre.
Increase the cutting height (see Par. 5.6).
Make a perimeter cut.
Exclude the area with the slope beyond the
allowed limits by delimiting it (see Par. 4.3)
EN