Stiga Stig 300 Instruction Manual page 39

4.7.9. GO-TO CUT POINTS
NOTE: Check the availability of this function on the STIGA.GO App.
The section "Go-To-Cut Points" (A) allows you to set one or more starting points for the robot lawn mower's
work in order to improve coverage in the different areas of the garden (see Par. 4.4). The number of
settable start points depends on the model of the robot lawn mower.
The work start points are defined using the following parameters:
• Distance from the starting point to the charging base measured along the perimeter cable (G).
• Direction to reach the work point (clockwise or anticlockwise) (G).
• Frequency of reaching the work point expressed in% of the total programmed work time (H).
EN
A
G H
4. INSTALLATION
35