Stiga Stig 300 Instruction Manual page 48

Procedure:
1. Press the "STOP" button (A) to open the cover (B) and access the control console (C).
2. Press the "MODE SELECT" button (F) until the icons of the functions you wish to activate fl ash. The
icons relating to the selected functions fl ash.
3. Press the "CONFIRM" push button (G). The icons of the selected functions light up steadily to confi rm
the action.
4. Close the cover (B).
5. The robot lawn mower will start working according to the set mode.
NOTE: If after pressing the "CONFIRM" button (G), the "SELECT MODE" button (F) is pressed,
the icons for the selected functions will start fl ashing again, requesting to confi rm the newly
selected function. Press the "CONFIRM" button (G). The icons return to a steady light.
NOTE: if the cover (B) is opened, either during work or with the robot in the base, the icons
relating to the selected functions will fl ash,to indicate that it is necessary to confi rm the operation
before closing the cover again. If the cover is closed without pressing the "CONFIRM" button
(G), the robot will not perform any task until a new command is given by the user.
NOTE: If the robot battery is low, the battery icon fl ashes red to indicate that the selected action
cannot be performed.
NOTE: NOTE: the robot lawn mower starts only after closing the cover (B).
NOTE: The robot lawn mower goes to the charging base with the cutting device switched off .
A
C
NOTE: The robot lawn mower can be used in "SINGLE WORK CYCLE" mode even without
programming the working hours via the App. This mode may not guarantee adequate coverage
of the garden, both in terms of time required and in terms of uniformity of the cutting result,
especially if the garden has an irregular shape. To achieve the maximum effi ciency of the robot
lawn mower, it is recommended to carry out programming (see par. 4.7).
44
5. OPERATION
D B
I
L
G
E F
EN