4.0 Overview
Locations given in the Repair Procedures are always referenced from the front of the printer as you are
facing the Control Panel. See figure 4.0.1.
The following notations apply:
•
Arrows in the illustrations show direction of movement.
•
At the bottom of each illustration is a number. In the illustration above the number is EGL_400. This
is the art number and is used by the developers for tracking and control of the art.
There are a number of steps you should follow each time before you begin a procedure:
1 Do not use force to remove or install printer components.
2 Use only the screw size and type designated in the REP. The wrong screw could easily damage
tapped holes.
3 Wear a wrist strap to dissipate static electricity, which may damage sensitive electronic parts, and
use a grounded mat when working with PWBs.
4 See Section 6 for the precise location of electrical connectors in the printer.
Xerox DocuPrint P1202 Service Manual
Figure 4.0.1 Printer Orientation.
Left
Front
www.printcopy.info
Rear
Right
egl_407a
3/99
4-3
Repair Procedures