Installing Additional Memory - Xerox DocuPrint P1202 Service Manual

5.6 Installing Additional Memory

The printer is equipped with 4Mb of resident base memory which is expandable to a total of 36Mb. The
base memory may be expanded by installing an additional Single Inline Memory Module (SIMM). By
doing this, the size of the receive buffer and the size of the font download buffer are increased. This also
enables the printing of more complex pages.
On the Controller PWB, there is only one SIMM slot dedicated to increase the printer memory. There are
four available SIMM options to increase the printer memory up to a total of 36Mb. All SIMMs are industry
standard EDO 72 pin 32-bit memory (no parity, 60 ns or faster), and are available in sizes of 4, 8, 16, or
32MB. When the SIMM is installed, the Controller PWB will automatically detect the memory and
increase the printer buffer size.
To install an additional memory module:
1 Switch off printer and disconnect the AC power.
2 Disconnect all cables from the back of the printer.
3 Remove the right side cover panel by pressing the latch down and pulling it out and up (Figure
5.6.0a).
4 Remove the metal plate by removing the screw holding it in place (Figure 5.6.0b).
Xerox DocuPrint P1202 Service Manual
Figure 5.6.0a Right Side Cover Removal
Figure 5.6.0a . Shield Removal
3/99
www.printcopy.info
5-29
egl_412b
egl_413b
General Procedures and Information