Charging; General; Hardware - Siemens SITOP UPS1600 Equipment Manual

Display name Data type
BufferingEndVoltage Float
Setpoint
BufferingValid Float
SupplyVoltage
TimeSetpoint
DischargeCutOff Float
VoltageSetpoint
3.10.6.10

Charging

Display name Data type
ChargingCurrent Float
Setpoint
ChargeEndVoltage Float
Setpoint
DisableChargingSet- Boolean
point
MaximumAllowed Float
ChargeCurrentSetpoint
3.10.6.11

General

Display name Data type
AlarmInvalidSupply Float
VoltageTimeSetpoint
DeviceOutputEnable Boolean
Setpoint
ResetEnableSetpoint Boolean
ResetTimeSetpoint Byte
ResistorTestInterval Byte
Setpoint
3.10.6.12

Hardware

Display name Data type
HardwareBattery Enumeration
ProfileClamp
HardwareBuffer Enumeration
ThresholdSwitch
HardwareBuffer Enumeration
TimeSwitch
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
Definition Description
AnalogItemType When battery voltage is lower than this voltage, the battery
charge is no longer sufficient. Buffering is stopped.
AnalogItemType When the SITOP UPS1600 is in buffer mode, time for which
the input voltage must be OK again before SITOP UPS1600
buffering is stopped and connected devices are operated
again with input supply.
AnalogItemType Voltage, where discharge of the battery is cut off
Definition Description
AnalogItemType Charge current
AnalogItemType Battery voltage when charging changes to trickle charging.
The battery is charged 100 %.
PropertyType Battery charging deactivated
AnalogItemType Setting the max. charge current
Definition Description
AnalogItemType Alarm filter: an alarm is only sent if it is pending for longer
than the configured time
PropertyType DeviceOutputEnableSetpoint
PropertyType When input voltage returns during buffering, the output is
switched off for a configurable time in order to reset con-
nected devices.
AnalogItemType Time for which the output of SITOP UPS1600 is switched off
when connected devices are reset.
AnalogItemType Battery test interval
Definition Description
MultiState The charge characteristic for batteries on signal terminals is
DiscreteType set. This setting is only applied if hardware settings are ef-
fective.
MultiState Trigger voltage for buffering - buffering is activated below
DiscreteType this value
MultiState Desired buffering time before device switches off
DiscreteType
Engineering and remote access
3.10 OPC UA server
171