Parameter Assignment; Parameters Of The Basic Device And Battery Module; Parameterizing Sitop Ups1600 - Siemens SITOP UPS1600 Equipment Manual

Engineering and remote access
3.5 SIMATIC STEP 7
3.5.4

Parameter assignment

3.5.4.1

Parameters of the basic device and battery module

The adjustable parameters of the basic unit SITOP UPS1600 and the SITOP BAT1600 battery
modules or SITOP UPS1100 are structured according to subgroups in SIMATIC STEP 7. These
subgroups are shown in the table below.
Subgroup
Buffer parameters
Reset parameters
Buffering parameters (2)
Maintenance
Third-party battery
Charging
Web server
OPC UA
NTP settings
PROFINET security
A detailed description of the individual parameters of the subgroups is contained in the
associated section under Parameterizing SITOP UPS1600 (Page 92).
3.5.4.2

Parameterizing SITOP UPS1600

The procedure is the same for all parameters. This section describes the general procedure to
reach the configuration dialog. The individual parameters and their possible values are
described in the following subsections.
Each parameter has a start value. A click on "Reset to initial values" resets all parameters of a
subgroup to the associated start value.
Preconditions
• The SITOP UPS1600 has been integrated in the opened project and networked.
Procedure
1. Open the Network view "NetPro" ("Options > Configure network").
The controller and the networked SITOP UPS1600 are displayed.
2. In the Network view click on SITOP UPS1600. The hardware configuration opens.
3. Double click in the hardware configuration on the SITOP UPS1600 entry in the station
window for slot 0.1.
4. In the configuration dialog click on the "Parameters" tab.
92
Description
Parameters to configure the response of the SITOP UPS1600 when buffering
Configuring the interruption when the supply voltage returns
Parameters for determining the possible buffer time
Battery test interval
Parameters for using third-party batteries
Parameters for the charging behavior:
• End-of-charge voltage
• Charge current
Web server settings
OPC UA server settings
Time synchronization via the Network-Time-Protocol
PROFINET safety settings
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76