Charging; General; Hardware - Siemens SITOP UPS1600 Manual

3.8.6.10

Charging

Display name
ChargingCurrent
Setpoint
ChargeEndVoltage
Setpoint
3.8.6.11

General

Display name
AlarmInvalidSupply
VoltageTimeSetpoint
DeviceOutputEnable
Setpoint
ResetEnableSetpoint
ResetTimerSetpoint
ResistorTestInterval
Setpoint
3.8.6.12

Hardware

Display name
HardwareBattery
ProfileClamp
HardwareBuffer
ThresholdSwitch
HardwareBuffer
TimeSwitch
HardwareBuffering
EnableClamp
HardwareEnable
ResetClamp
HardwareStartFrom
BatteryClamp
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
Data type Definition
Float AnalogItemType Charge current
Float AnalogItemType Battery voltage when charging changes to trickle charging.
Data type Definition
Float AnalogItemType Alarm filter: an alarm is only sent if it is pending for longer
Boolean PropertyType
Boolean PropertyType
Byte AnalogItemType Time for which the output of SITOP UPS1600 is switched off
Byte AnalogItemType Battery test interval
Data type Definition
Enumeration MultiState
DiscreteType
Enumeration MultiState
DiscreteType
Enumeration MultiState
DiscreteType
Boolean PropertyType
Boolean PropertyType
Boolean PropertyType
Description
Battery is charged 100 %.
Description
than the configured time
DeviceOutputEnableSetpoint
When input voltage returns during buffering, the output is
switched off for a configurable time in order to reset con-
nected devices
when connected devices are reset.
Description
The charge characteristic for batteries on signal terminals is
set. This setting is only applied if hardware settings are
effective.
Trigger voltage for buffering - buffering is activated below
this value
Desired buffering time before device switches off
Enable buffering
When input voltage returns during buffering, the output is
switched off for a configurable time in order to reset con-
nected devices
Setting for 'Start from battery' on signal terminal
Engineering and remote access
3.8 OPC UA server
173