Siemens SITOP UPS1600 Equipment Manual page 83

Navigation area
Retrieve the online and diagnostics data of SITOP UPS1600
Proceed as follows to start the online and diagnostics view of the particular module:
Project tree:
1. Open the device folder of the SITOP UPS1600 in the Project tree. This is located (after the
assignment to the control system) in the folder of the control system under "Distributed
I/O " > [name of the PROFINET connection].
2. Double-click on "Online & diagnostics".
Alternatively:
3. Select the device folder of the SITOP UPS1600 in the Project tree.
4. In the shortcut menu or in the "Online" main menu, select the "Online & diagnostics" .
Device view:
1. Open the device view of the device configuration.
2. Select the SITOP UPS1600.
3. In the shortcut menu or in the "Online" main menu, select the "Online & diagnostics" .
Network view:
1. Open the network view of the device configuration.
2. Select the SITOP UPS1600.
3. In the shortcut menu or in the "Online" main menu, select the "Online & diagnostics" .
4. Click on "Connect online".
The information is displayed under "Diagnostics / General".
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
Assign name
Reset to factory settings
IP address
PROFINET device name
Engineering and remote access
3.4 SIMATIC STEP 7 in the TIA Portal
Value
Firmware version
Suitable for modules with
Status
Activate firmware after update
PROFINET device name
Type
MAC address
83