Paradyne FrameSaver 9620 User Manual page 67

9621-A2-GB20-30
Message What It Indicates
Low Compression Access unit's compression
Ratio ratio falls below the
specified compression ratio
threshold.
Please Wait Command takes longer
than 5 seconds.
Resetting Device, Yes (or y) was entered in
Please Wait ... the Reset COM Port usage
field of the System Paused
menu.
Test Active No higher priority health
and status messages exist,
and a test is running.
User Interface Already Access to the user interface
in Use via the COM port or Telnet
is already in use; access to
the interface is denied.
IP address and login of the
user currently accessing
the interface are also
provided.
User Interface Idle
Previously active session is
now closed/ended, and
access via the COM port is
now available.
Session has been ended
due to timeout.
August 1997
Maintenance and Troubleshooting
What To Do
Raise the Compression Ratio
Threshold.
Verify whether compressed
data is already being sent.
Check Compression Ratio
setting to verify that a
compression ratio is expected.
Wait until message clears.
No action needed.
Contact service provider if test
initiated by the network.
Wait until the other test ends
and message clears.
Cancel all tests from the Test
screen ( Path: main/test ).
Stop the test from the same
screen the test was started
from.
Wait and try again.
Contact IP address user and
request that they log off.
Log onto the access unit.
No action needed.
5-13