Paradyne FrameSaver 9620 User Manual page 36

9621-A2-GB20-30
Message What It Indicates
Latching DSU LB A network-initiated latching
1
Active DSU Loopback is currently
running on a 64 kbps clear
channel circuit.
Mon. 511 on Network Access unit is monitoring a
511 test pattern on the DDS
network interface.
When status is Active,
whether synchronization
was achieved, as well as
the number of data errors
are displayed.
Mon. 511 on Port- n Access unit is monitoring a
511 test pattern over the
specified port interface.
When status is Active,
whether synchronization
was achieved, as well as
the number of data errors
are displayed.
Mon Pattern, Access unit is monitoring
3
DLCI nnnn , interface the Hex 55 test pattern on
the specified DLCI for the
interface.
When status is Active, the
amount of time the test has
been running and the
number of errors during that
time are displayed.
Non-Latching CSU LB A network-initiated
1
Active non-latching CSU or Local
Loopback is currently
running.
1
A non-latching loopback can only be initiated and terminated by the network service
provider.
2
A count of 99999+ means that the maximum number of errors has been exceeded.
3
nnnn indicates a DCLI number of 16 through 1007; interface is Network, Port-1,
Port-2, or the basic rate interface B channel.
August 1997
Displaying System Information
What To Do
No action needed.
If the test is running but the
network has not initiated it,
change the configuration
option.
See Device Messages
Chapter 5.
Allow the test to continue.
Press Return ( ) while the
test is selected on the
Network Physical Tests screen
( Path: main/test/physical ) to
activate or deactivate the test.
2
2
Continue monitoring test.
Press Return ( ) while the
test is selected (via the
Command column) on the
interface's PVC Tests screen
( Path: main/test/ [network/
port-1/port-2/BRI] _ pvc ) to
activate or deactivate the test.
2
No action needed.
If the test is running but the
network has not initiated it,
change the configuration
option.
See Device Messages
Chapter 5.
in
in
4-11