Device Messages; Device Error Messages - Paradyne FrameSaver 9620 User Manual

Device Messages

Device Error Messages

9621-A2-GB20-30
All device messages are listed in alphabetical order.
These messages appear in the messages area at the bottom of the screens.
Message What It Indicates
1
Access level is n User's access level is 2
Configuration is or 3; user is not authorized
Read-only. to change configurations.
Compression Compression features of
Connection Failure the local and far-end
access units are
disconnected.
Duplicate DLCI DLCI number entered is not
Number unique for the port.
Destination Cannot Be Destination field was
Blank skipped when setting up an
ISDN Call Profile.
Destination Not Destination entered is
Unique already being used.
2
Invalid Character ( x )
A non-valid printable ASCII
character has been
entered.
Invalid – [ Test ] A test was already in
Already Active progress when it was
selected.
Invalid – [ CSU/ DTE ] Network-initiated loopback
Network Initiated was in progress when CSU
Loopback Active (or DTE ) Loopback Start
was selected.
Invalid Password Login is required and an
incorrect password was
entered; access is denied.
1
n is Access Level: 2 or 3.
2
x is the character not being accepted.
August 1997
Maintenance and Troubleshooting
What To Do
No action needed.
Verify that the access units at
both ends are configured for
compression and that the DLCIs
are properly configured.
No action needed; previous
contents of the DLCI number
field is restored.
Tab to Destination, and enter a
unique 8-character destination
indicator (e.g., Florida).
Enter another destination
indicator.
Re-enter information using valid
characters.
No action needed.
No action needed.
Selecting Abort All Tests from the
Test menu ( Path: main/test ) will
not interrupt a network-initiated
loopback.
Try again.
Contact your system
administrator to verify your
password.
5-9