Table of Contents
Advertisement
9 Manufacturer's information
9 Manufacturer's information
9.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
9.2 Packaging
The product is packaged in a cardboard box which can be re-
cycled as paper.
9.3 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
9.4 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
10 Assembly and installation
Pay attention to the information on product labels, in
●
product documentation and EC type examination certific-
ate.
Connect cable carefully, do not damage individual wires.
●
When connecting multiwire or finewire cables, prepare
●
the wire ends.
Always use suitable pinch tools for pinching wire end fer-
●
rules in order to achieve consistent quality.
Tighten all clamping points, even the ones not being
●
used.
1. Observe the national regulations and provisions.
2. Observe the installer provisions.
3. Protect M12 plugs against electrostatic build-up.
4. Protect M12 plugs against damage.
5. Lay cables securely and protect them from damage.
6. Differential voltage for two intrinsically safe electric cir-
cuits: maximum 30 V.
7. Connect open wire ends in a junction box with protection
class IP20 and higher or outside the EX area.
GEMÜ 1242
NOTICE
10.1 Mounting kit assembly
Item
Name
1
Spindle
2
Spring
3
Operating bush
4
Distance piece
5
O-ring
6
Adapter
* Included depending on version.
Pretensioned spring!
▶ Damage to the device.
Slowly release the tension in the spring.
●
Do not scratch the spindle!
▶ A damaged spindle surface may cause failure of the
travel sensor.
1
1. Pull out the spindle
1.
14 / 41
Item
Name
7
Flange plate
8
Screws
9
Pressure disc*
10
O-ring*
11
O-ring*
CAUTION
CAUTION
1
4
2
3
2. Align the indentation of the distance
piece 4 to the spring and push it over
the spindle 1 using the spring 2 and fix
it in place using the operating bush 3.
5
6
www.gemu-group.com
Advertisement
Table of Contents
