GEM 1242 Operating Instructions Manual page 12

7 Technical data
7.4 Electrical data
Electrical connection
type:
Supply voltage:
Duty cycle:
Electrical protection
class:
Reverse battery protec-
tion:
Switching characteristic:
Switch points:
GEMÜ 1242
1 x 5-pin M12 plug (A-coded)
1 x 8-pin M12 plug (A-coded)
24 V DC (18 to 30 V DC) (according to IO-Link specifications)
26.5 to 31.6 V DC (according to AS-Interface specifications)
11 to 25 V DC (according to DeviceNet specifications)
Continuous duty
III
yes
Stroke %
100%
Switch point "Open"
Switching hysteresis
Switching hysteresis
0%
Switch point "Closed"
Switching output "Open"
active
inactive
Switching output "Closed"
active
inactive
Switch points: The data in percent refer to the programmed stroke, before each end position
Default setting switch point CLOSED
Default setting switch point OPEN
Min. switch point CLOSED
Min. switch point OPEN
If the percentage switch points dependent on the programmed stroke are smaller than the permiss-
ible min. switch points, the min. switch points apply automatically.
td1 td1
td1
Size 1
12%
25%
0.8 mm
0.5 mm
12 / 41
t/ms
td1: Signal delay
td2: Signal delay
t/ms
ta
ta: Signal interval
t/ms
td1 td2
Size 2
12%
25%
2 mm
1.25 mm
www.gemu-group.com