GEM 1242 Operating Instructions Manual page 29

13 Specific data – IO-Link
Last position open
AD value of the last approached OPEN position.
Last position closed
AD value of the last approached CLOSED position.
Last stroke
Determined stroke of the linear actuator during the last completed switching cycle (in AD values). The change in valve stroke
can be calculated in conjunction with the parameter Programmed stroke.
Valve cycles user
Customer-adjustable switching cycle counter.
Counts the valid switching cycles.
A switching cycle is valid if the valve travels from one defined end position to the other defined end position and returns to the
original end position. If an end position is not reached, the switching cycle is not valid and is not counted.
Valve cycles total
Factory-set total switching cycle counter (cannot be reset).
Counts the valid switching cycles.
A switching cycle is valid if the valve travels from one defined end position to the other defined end position and returns to the
original end position. If an end position is not reached, the switching cycle is not valid and is not counted.
Counter Powerfail
Power failure counter.
Counter Power on
Power on counter.
Counter Programming
Executed end position programming processes counter.
Counter Sensor calibration
Executed travel sensor calibrations counter.
Counter Prog error no stroke
Programming error counter/no stroke.
Counter Prog error less stroke
Programming error counter/stroke < min. stroke.
Counter Prog error after sensor error
Programming error counter/after sensor error.
Counter Sensor error open
Sensor error counter/OPEN position.
Counter Sensor error closed
Sensor error counter/CLOSED position.
Counter over temperature
Over-temperature counter.
Actual AD-value
Current value of AD converter.
www.gemu-group.com 29 / 41 GEMÜ 1242