Correct Use; Information On Use In Damp Conditions; Manufacturer's Information; Delivery And Performance - GEM 1230 Installation, Operating And Maintenance Instructions

1.4

Correct use

Only use the electrical position indicator
for electrical and optical position detection
for linear actuators in accordance with the
technical data (see chapter 11). Any other
use or use above and beyond this is not
permitted. GEMÜ shall not be liable for any
consequential damage. The user carries
sole risk.
Please pay attention to the pertinent
technical safety regulations when planning
both the use and operation of the device.
Take appropriate measures to exclude
accidental operation and non-permissible
influences. The designer, plant constructor
or operator is always responsible for
positioning and mounting of the GEMÜ
electrical position indicator.
1.5 Information on use
in damp conditions
Use the electrical position indicator
in accordance with its protection
class (IP 65 acc. to EN 60529)!
The following information is intended to
help when mounting and operating the
GEMÜ electrical position indicator in damp
conditions.
Lay cables and pipework so that
G
condensate or rain water that remains
on the pipework / cables cannot enter
the cable glands of the electrical position
indicator.
Check that all cable glands are
G
mechanically secured.
Check gasket R for any damage and for
G
correct positioning before each closure.
1230
2

Manufacturer's information

2.1
Check that all parts are present and
G
check for any damage immediately upon
receipt.
The scope of delivery is apparent from the
dispatch documents and the design from the
order number.
The performance of the electrical position
indicator is checked at the factory.
If the electrical position indicator is ordered
as a complete unit with a valve, these parts
as well as the accessories are supplied
ready assembled and programmed by the
factory.
2.2
Store the electrical position indicator
G
free from dust and moisture in its original
packaging.
Avoid UV rays and direct sunlight.
G
Do not exceed the maximum storage
G
temperature of 60 °C.
2.3
The tools required for installation and

assembly are not included in the scope
of delivery.
Use appropriate, functional and safe
G
tools.
R
18 / 32

Delivery and performance

Storage

Tools required