Troubleshooting - Toro Z Master 2000 Series Operator's Manual

Troubleshooting

Problem
Abnormal vibration.
Reduced bagging performance.
Blower and tubes plug too frequently.
Debris blowout.
Blower impeller does not spin freely.
Possible Cause
1. Cutting blade(s) is/are bent or
unbalanced.
2. Blade-mounting bolt is loose.
3. Loose blower pulley or pulley
assembly.
4. Worn bagger belt.
5. Blower fan blade(s) is/are bent or
unbalanced.
1. Low engine speed.
2. Plugged screen in bagger hood.
3. Loose bagger belt.
4. A plugged tube or blower.
5. Full bags.
1. Bags are too full.
2. Low engine speed.
3. Grass is too wet.
4. Grass is too long.
5. Plugged screen in hood.
6. Ground speed is too fast.
7. Worn bagger belt.
1. Bags are too full.
2. Ground speed is too fast.
3. Mower deck is not leveled.
1. Plugged blower.
2. Impeller not aligned.
32
Corrective Action
1. Install new cutting blade(s).
2. Tighten the blade-mounting bolt.
3. Tighten the appropriate pulley.
4. Replace the belt.
5. Contact an Authorized Service Dealer.
1. Always operate the engine at full
throttle.
2. Remove debris, leaves or grass
clippings from the screen.
3. Replace the bagger belt.
4. Locate and remove plugged debris.
5. Empty the hopper.
1. Dump more frequently.
2. Always operate the engine at full
throttle.
3. Cut grass when it is dry.
4. Cut no more than 51-76 mm (2-3
inches) or 1/3 of the grass height,
which ever is less.
5. Remove debris, leaves or grass
clippings from the screen.
6. Drive slower at full throttle.
7. Replace belt.
1. Dump more frequently.
2. Drive the machine at slow ground
speed while operating the engine at
full throttle.
3. See the machine Operator's Manual
for leveling the mower deck.
1. Remove debris, leaves or grass
clippings from the blower impeller.
2. Contact an Authorized Service Dealer.