Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
Description
No parts required
Left bumper
Left frame-support bracket
Right bumper
Right frame-support bracket
Carriage bolt (3/8 x 1-1/4 inches)
Flange nut (3/8 inch)
Tailpipe extension
Washer-head screw (#8 x 1/2 inch,
self-threading)
Exhaust shield
Flange-hex-head bolt (3/8 x 1 inch)
Nut (3/8 inch)
Exhaust shield
Flange-hex-head bolt (3/8 x 1 inch)
Nut (3/8 inch)
Hopper-support frame
Hairpin
Hood hold-down rod
Bagger hood
Baffle
Hairpin (small)
Hood assembly
Bag
Blower (from the blower and drive kit)
Blower belt (from the blower and drive
kit)
Blower assembly (from the blower and
drive kit)
Spring (from the blower and drive kit)
Belt cover (from the blower and drive kit)
Cover knob
Upper discharge tube
Screw (1/4 x 3/4 inch)
Locknut (1/4 inch)
Lower discharge tube
Qty.
–
Prepare the mower.
1
1
1
Install the side bumpers and support
brackets.
1
6
6
1
Install the muffler extension.
1
1
2
Drill the exhaust-shield mounting holes.
2
1
3
Install the exhaust heat shield.
3
1
Install the bagger mounting brackets.
2
1
1
1
Install the hood baffle.
2
1
Install the hood assembly and bags.
2
1
Route the blower belt into the blower
assembly.
1
1
Install the blower assembly.
1
1
Install the belt cover.
1
1
3
Install the discharge tubes.
3
1
5
Use