Toro Z Master 2000 Series Operator's Manual page 15

1
2
3
Hood Installation
1. Hood
2. Hood bracket with keyhole
slot
3. Hopper-support frame
3. Rotate the hood so that the keyhole slot is up, and align
the hood to the right of the keyed-pivot pins
16).
4. Assemble the hood to the hopper frame by sliding the
keyhole brackets over the keyed pins
5. Rotate the hood down to secure the hood to the
hopper-support frame as shown in
Install the air-cleaner cover as follows:
Note: Ensure that the primary air filter is fully seated by
pushing on its outer rim.
Important: Do not press on the soft inside area of the
filter
4
5
Figure 16
4. Pivot bracket with
keyed-pivot pin
5. Hood installed
(Figure
Figure 16.
1. Position the air-cleaner cover so that the breather valve
is located at approximately 5 o'clock
3
G018610
1. Air-cleaner cover
G018361
2. Breather valve
2. Secure the latches
Install the bag assemblies onto the hopper-support frame
as follows:
1. Raise the hood to expose the notched-bag brackets on
the hopper-support frame as shown in
(Figure
16).
15
1
2
Figure 17
Air-Cleaner Cover
3. Air-cleaner latch
(Figure 15).
(Figure 17).
3
Figure 18.