Installing The Hopper Support Frame And Hood Rod - Toro Z Master 2000 Series Operator's Manual

3
1
1 2
Figure 10
Heat-Shield Installation on International (TE) Mower
1. Lower-left engine guard
2. Exhaust shield
3. Flange-hex-head bolt (3/8
x 1 inch)
2. For Domestic (US) Mowers, align the holes in the
right flange of the exhaust guard with the holes in the
back of the lower-left bumper
For International (TE) Mowers, align the holes
in the right flange of the exhaust guard with the 2
left-most-vertical slots in the back of the lower-left
engine guard (Figure
3. Secure the heat shield to the engine guard with the 3
flange-hex-head bolts (3/8 x 1 inch) and 3 flange nuts
(3/8 inch) (Figure 9
or Figure 10 for International (TE) mowers.)
4
2
4
6
G018365
4. Nut (3/8 inch)
5. Flange nut (lower-left
engine guard,
back-mounting point)
6. Tailpipe extension
(Figure 9).
10).
for US Domestic (US) mowers
6
Installing the Hopper Support
Frame and Hood Rod
Parts needed for this procedure:
1 Hopper-support frame
2 Hairpin
5
1 Hood hold-down rod
Procedure
Install the hopper-support frame as follows:
1. Align the hopper-support frame so that the 2
keyed-hood pins on the top of the frame are pointing
to the right, and the mounting pin on the bottom of
the frame is pointing to the left as shown in
Hopper-Support Frame Installation
1. Hopper-support frame
2. Keyed-hood pins
3. Mounting pin
2. Insert the hopper-support frame into the square-shaped
opening of the left frame-support bracket
3. Align the mounting pin to the right of the right
frame-support bracket
4. Lower the frame between the U-shape tabs of the of
the right bracket
12
2
1
4
Figure 11
4. Left frame-support bracket
5. Right frame-support
bracket
6. Hairpin
(Figure
(Figure 11).
(Figure 11).
Figure 11.
5
3
6
g018359
11).