Maintenance; Recommended Maintenance Schedule(S); Preparing For Maintenance; Cleaning The Hood Screen - Toro Z Master 2000 Series Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours

Preparing for Maintenance

Do the following steps before preforming maintenance on
the machine:
1. Park the machine on a level surface.
2. Disengage the PTO, move the motion control levers
to the N locked position, and set the parking
EUTRAL
brake.
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Clean the mower of any debris on the deck or rear part
of the mower to ease maintenance.

Cleaning the Hood Screen

Service Interval: Before each use or daily
1. Disengage the power take off (PTO) and set the
parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Open the bagger hood.
4. Clean the debris from the screen.
5. Close the bagger hood.

Cleaning the Bagger and Bags

Service Interval: Before each use or daily
1. Wash the inside and outside of the bagger hood, bags,
tube, and the underside of the mower.
Note: Use a mild automotive detergent to remove dirt.
2. Ensure that you remove matted grass from all parts.
3. After washing all parts, let them dry thoroughly.
Note: With all parts installed, start and run the machine for
a minute to assist in drying.
Maintenance Procedure
• Inspect the blower belt.
• Inspect the bagger.
• Clean the hood screen.
• Clean the bagger.
• Inspect the blower belt.
• Grease the idler arm.
• Inspect the bagger.

Inspecting the Blower Belt

Service Interval: After the first 8 hours
Every 25 hours
Check belts for cracks, frayed edges, burn marks or any other
damage. Replace damaged belts.

Replacing the Blower Belt

1. Disengage the PTO, move the motion control levers
to the N
EUTRAL
brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Pull back on the spring-loaded idler pulley to relieve
the belt tension
1. Idler pulley
2. Mower-deck pulley
3. Spring
29
locked position, and set the parking
(Figure 39).
Figure 39
4. Spring peg
5. Belt
6. Blower pulley