Installing The Exhaust Shield - Toro Z Master 2000 Series Operator's Manual

Important: Ensure that the drill bit does
not contact the muffler when drilling the
heat-shield-mounting hole in the lower-left engine
guard.
5

Installing the Exhaust Shield

Parts needed for this procedure:
1 Exhaust shield
3 Flange-hex-head bolt (3/8 x 1 inch)
3 Nut (3/8 inch)
Procedure
Install the exhaust guard on the lower-left bumper as follows:
1. Align the hole of the exhaust-guard left flange to the
hole in the small, angular area of the engine guard as
illustrated in Figure 9
in Figure 10 for International (TE) mowers.
for Domestic (US) mowers or
3
1
1
Heat-Shield Installation on US Domestic Mower
1. Lower-left engine guard
2. Exhaust shield
3. Flange-hex-head bolt (3/8
x 1 inch)
11
4
2
4
2 6
Figure 9
4. Nut (3/8 inch)
5. Flange nut (lower-left
engine guard,
back-mounting point)
6. Tailpipe extension
5
G018364