Advanced Programming Parameters (5 - Cycle Softener System) - Pentair AUTOTROL MAGNUM 293 Installer Manual

6.4.2

Advanced programming parameters (5 - Cycle softener system)

Parameter
description
P9 Units of measure
P10 Clock mode
P11 Service interval
P12 Remote
regeneration
P13 Chlorine
generator
options
P14 Refill rate
P15 Draw rate
P16 Reserve type
P17 Initial average or
fixed reserve
P18 Flow sensor
select
P19 K-factor or pulse
equivalent
* Default value selected with valve type and resin volume.
** Factory default value is "0" for North America and "1" for World units.
Ref. MKT-IM-012 / D - 03.02.2022
Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
Range of Default
values value
0 - 1 **
0 - 1 **
0 - 250 0
3 - 250 0
0 - 2 0
1 - 700 *
1 - 700 *
0 - 3 0
0 - 70 30
0 - 5 *
1.00 -99.99 0.01
0 - 9999 1
Units of
measure
N/A 0 = US unit.
1= Metric unit.
N/A 0 = 12 hours clock.
1 = 24 hours clock.
Months Uses 30 days for each month.
Months Time remote switch must be
active to start regeneration on
742 controller.
N/A 0 = no chlorine generator.
1= salt check only.
2 = generate chlorine.
gpm x 100 -
gpm x 100 -
N/A 0 = variable reserve delayed
regeneration.
1 = fixed reserve delayed
regeneration.
2 = variable reserve immediate
regeneration.
3 = fixed reserve immediate
regeneration.
% of capacity Depends on value selected for
P16.
N/A 0 = internal Magnum NHWB.
1 = 1" Autotrol turbine.
2 = 2" Autotrol turbine.
3 = User defined.
K-factor,
4 = User defined pulse
equivalent.
5 = internal Magnum HWB.
N/A K-factor P18 = 3.
Pulse equivalent P18 = 4.
Notes
57 / 110