Advanced Programming; Basic Programming Parameters (5 - Cycle Softener System) - Pentair AUTOTROL MAGNUM 293 Installer Manual

Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
6.4

Advanced programming

Info
Press and hold
A "P" symbol is displayed on the bottom left of screen
6.4.1

Basic programming parameters (5 - Cycle softener system)

Parameter
description
P1 Time of day
P2 Day of week
P3 Time of
regeneration
P4 Calendar
override
P5 Day of week
regeneration
P6 Salt setting
P7 Capacity of unit
P8 Hardness of
water
*Calculated depending on salt setting and resin volume. The capacity may be manually adjusted.
56 / 110
+ for 5 seconds to access advance programming.
Range of Default
values value
1:00 - 12:59 12:00 PM
AM
0:00 - 23:59
PM
N/A None
1:00 - 2:00 AM
12:59AM
0:00 -
23:59PM
0 - 99 3
N/A None
50 - 290 110
0.1 - 90 *
30 - 2000 400
Units of
measure
Hour : Range depends on value
selected for P10.
minute
N/A -
Hour: Range depends on value
selected for P10.
minute
Days 0 = no calendar override.
0.5 = regeneration twice a day at
time of regeneration and
12 hours later.
Calendar override skipped if at
least one day of regeneration
selected.
N/A Day of week regeneration is
skipped if calendar override is
more than 0 (742 controller
only).
g/l Unit of measure depends on
value selected for P9.
kg Unit of measure depends on
value selected for P9.
g/l Unit of measure depends on
value selected for P9
(762 controller only).
Ref. MKT-IM-012 / D - 03.02.2022
Notes