Programming; Display - Pentair AUTOTROL MAGNUM 293 Installer Manual

Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
6

Programming

6.1

Display

1. Hourglass
2. Cursor
3. Days of the week
4. Locked/unlocked indicator This symbol is display in basic programming when the current
5. Colon
6. Indicator
7. Cursor
8. Cursor
46 / 110
Displayed when the motor is running. The camshaft should be
turning.
These cursors appear next to the item that is currently
displayed.
Displayed days of the week. The flag below the day appears
when that day has been programmed as a day the system
should regenerate (used with 7-day timer programming).
parameter is locked-out.
It is also used in advanced programming to indicate if the
displayed parameter is locked when the controller is in basic
programming (the icon flashes).
Colon flashes as part of the time display.
It also indicates normal operation (742 only).
Indicator for day regeneration programming.
This cursor is displayed when the days between regeneration
are being programmed (used with 0.5 to 99 day regeneration
programming).
One of these cursors is displayed to indicate which day is
programmed into the controller.
Ref. MKT-IM-012 / D - 03.02.2022