Reset The Lx60 To Factory Default Settings; Recovery Mode - Airlink101 LX60 Hardware User's Manual

Reset the LX60 to Factory Default Settings

To reset the router to the factory default settings:
•
Note: When you use ACEmanager to reset the router to the factory default settings, some settings
such the user password, network ID, network password, custom APNs, low voltage standby are
preserved by default. However, you can configure the LX60 Reset Mode to reset all values,
including the user password. For more details, refer to the ALEOS Software Configuration User
Guide (Admin chapter).
•
Warning:
user password, no matter what Reset Mode you have configured in ACEmanager. The Reset button
can be disabled in ACEmanager if required. Before installation, please record the default password
on the device label and store it in a secure place.
Avertissement :
par défaut, y compris le mot de passe utilisateur, quel que soit le mode de réinitialisation que vous
avez configuré dans ACEmanager. Ce bouton peut être désactivé dans ACEmanager si nécessaire.
Avant déploiement de l'unité, veuillez enregistrer le mot de passe indique sur l'étiquette et le garder
dans un endroit sûr.

Recovery Mode

If the router fails to boot properly, it automatically enters recovery mode, or, if the router is
unresponsive to ACEmanager input and AT commands, you can manually put the router
into recovery mode.
Recovery mode enables you to update the ALEOS software and return the router to
working order. (For details, refer to the ALEOS Software Configuration User Guide—
Configuring your router chapter.)
To enter Recovery mode manually:
•
To recover the router:
•
Note: After the recovery, you need to reload the radio module firmware store and templates.
Rev. 2 June 2021
In ACEmanager, go to Admin > Advanced and click the Reset to Factory Default
button.
–Or–
On the router, press the Reset button for between 5 and 20 seconds. (Release the
button when the Power LED flashes red.)
Once the LEDs resume their normal operating behavior, the reset is complete.
Using the Reset button as described above resets all settings to default, including the
L'utilisation du bouton comme décrit ci-dessus réinitialise tous les paramètres
On the router, press the Reset button for more than 20 seconds. (Release the button
when the Power LED flashes amber.)
Update ALEOS using the Recovery mode interface. Once the new ALEOS version is
successfully uploaded and installed, the router reboots and exits recovery mode.
When the process is complete, the ACEmanager login screen appears.
35
Installation and Startup
41111782