Airlink101 LX60 Hardware User's Manual page 19

Fixed Installation
For fixed installations, connect the wires as shown in the figure below. You can configure
Low voltage disconnect to force the router into Standby mode when the voltage is low.
Voltage is monitored on Pin 1 (red wire).
Figure 2-6: Fixed Installation without I/O
•
•
•
Fixed Installation with I/O Input Triggered by Standby Mode
If you have a fixed installation where you want to use the I/O to monitor an external device
such as a motion detector, remote solar panel, or a remote camera, refer to
You can configure the I/O line to wake the router up for a configured length of time, and
use low voltage disconnect to put the router in Standby mode if the voltage falls below a
configured value.
Figure 2-7: Fixed Installation with I/O
•
•
•
Rev. 2 June 2021
7.5 A Fuse
4 A fuse
DC power source
DC Power Source
Pin 1 (Power) —Use the red wire in the DC cable to connect Pin 1 to the power
source. Include a 4 A, fast blow fuse, recommended to have no more than ±10% de-
rating over the operating temperature range, in the input power line. Sierra Wireless
recommends using a continuous (unswitched) DC power source.
Pin 2 (Ground)—Use the black wire in the DC cable to connect Pin 2 to ground. See
also Step 2—Mount and Ground the LX60 Chassis
Pin 3 (On/Off control)—Connected to power
7.5 A Fuse
4 A fuse
DC power source
DC Power Source
Motion Sensor
Motion sensor
Pin 1 (Power) —Use the red wire in the DC cable to connect Pin 1 to the power
source. Include a 4 A, fast blow fuse, recommended to have no more than ±10% de-
rating over the operating temperature range, in the input power line. Sierra Wireless
recommends using a continuous (unswitched) DC power source.
Pin 2 (Ground)—Use the black wire in the DC cable to connect Pin 2 to ground. See
also Step 2—Mount and Ground the LX60 Chassis
Pin 3 (On/Off control)—Connected to power
LX60 router
1 Power
3 On/Off
1
Power
LX60
3
Ignition Sense
4 I/O
4
I/O
2 Ground
2
Ground
LX60 router
1 Power
3 On/Off
1
Power
LX60
3
Ignition Sense
4 I/O
4
I/O
2 Ground 2
Ground
19
Installation and Startup
on page 13.
Figure
on page 13.
2-7.
41111782