Airlink101 LX60 Hardware User's Manual page 26

AirLink LX60 Series Hardware User Guide
You can connect any of these pins to a digital input to detect the state of a switch such as
a vehicle ignition, or to monitor an external device such as a motion detector, a remote
solar panel, or a remote camera. Digital input can also be used with the standby timer.
The primary digital input of Pin 4 on the power connector can be used to wake the router
from standby. The four digital inputs on the I/O connector do not have this functionality.
Figure 2-12: Digital Input
Table 2-5: Digital Input
Pull-up
Off
Rev. 2 June 2021
Pin 4 (power connector), or
Digital Input
State Minimum
Low —
High 2.7 V
LX60
V
in
V
High
Protection
Circuitry
* Configurable on the ACEmanager I/O tab
Typical Maximum
— 1.0 V
— V
in
26
Internal pull-up
resistor
Off (default)*
41111782